Hello,

I have a Cobalt Cache Raq. when I boot the NetBSD Kernel (Jun 27 1.5-Alpha),
the boot process stop at this point:


pciide0 at pci0 dev 9 function 1: VIA Tech VT82C586A IDE Controller (rev.
0x06)
pciide0: bus-master DMA support present
pciide0: primary channel configured to compatibility mode
wd0 at pciide0 channel 0 drive 0: <ST330630A>
wd0: drive supports 16-sector pio transfers, lba addressing
wd0: 29188 MB, 16383 cyl, 16 head, 63 sec, 512 bytes/sect x 59777640 sectors
wd0: 32-bit data port
wd0: drive supports PIO mode 4, DMA mode 2, Ultra-DMA mode 4
pciide0: primary channel interrupting at irq 14
wd0(pciide0:0:0): using PIO mode 4, Ultra-DMA mode 2 (using DMA data
transfers)
pciide0: secondary channel configured to compatibility mode
pciide0: secondary channel ignored (disabled)
VIA Technologies VT83C572 USB Controller (USB serial bus, revision 0x02) at
pci0
 dev 9 function 2 not configured
tlp1 at pci0 dev 12 function 0: DECchip 21143 Ethernet, pass 4.1
tlp1: interrupting at level 2
tlp1: Ethernet address 00:10:e0:00:2a:a3
lxtphy1 at tlp1 phy 1: LXT970 10/100 media interface, rev. 3
lxtphy1: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
boot device: wd0
root on wd0a dumps on wd0b
pciide0:0:0: lost interrupt
        type: ata tc_bcount: 512 tc_skip: 0



any ideas?!?!





***************************************
I-Net:  http://alialadin.homeip.net
e-mail: alialadin@alialadin.homeip.net
***************************************