On Mon 17 May, Leo Smiers wrote:
> On Sun 16 May, Martin Kaletsch wrote:
> > Hello!
> > 
> > I just downloaded the RiscBSD Kernel 1.4 and the essential binarys and for
> > some hours have been trying to install the system.
> > 
> > I hoped that it was possible to mount one of my SCSI-Drives (Quantum Fireball
> > HD, Syquest EZ135 on Connect 32 SCSI 2 Hardwar 1.01 Software 0.22) during
> > installation and install the binarys from there. The BSD-partition shall be
> > on my IDE HD (on motherboard controller).
> > 
> > All that is happening on an SA-RPC with 24 MB RAM and 2 MB VRAM.
> > 
> > I booted into the install kernel okay, but then it is not possible to
> > mount_filecore my SCSI drives. Everytime I try, the computer just freezes.
> > The same happens when I try to mount my SCSI CD-ROM. 
> The Connect32 driver in the distributed kernel is broken. I have made a fix
> and sent it to Mark. 
> 
> To be of any help now I have put the kernel I use at my
> website. This is not a install kernel and I have removed some drivers I do
> not need. This kernel was built from sup sources at 14 may.
> 
> I must warn you I have not tried this kernel with SCSI discs
> only with CDROM's and a tape drive so I can not garanty anything. If you
> lose any data I will not be responsible!
> 
> I hope this is of any help to you. The url is http://people.a2000.nl/lsmiers
> 
> I will build a normal RISCPC kernel as soon as I have sent this mail. When
> ready I will replace the RAVEL kernel tomorrow with the RISCPC one.
I have now put a RISCPC kernel at my website. 

Leo

-- 
Leo Smiers
Software Engineer                          bv Nederland Haarlem
Author of !PDF, current version 0.73a      http://people.a2000.nl/lsmiers