> On Thu, 5 Mar 1998, Peter Berg wrote:
> 
> > Hi,
> > 
> > now I have fitted a EtherM card into my RiscPC. If the card works, it works 
> > very well, but:
> > 
> > after *each* power down reset the kernel crashes at the etherM 
> > initialisation stage with
> > 
> > em0 at podulebus0 [ netslot 0 ]
> > em0: Ethernet address 00:00:a4:10:ba:2b
> > em0: 16KB buffer memory, jabber, UTP
> > Fault with intr_depth > 0
> > Data abort: "Translation fault (page)' status = 007 address = f018b000 PC = 
> > f01265b4
> > Instruction @Vf01265b4 = e52d0004
> > Stopped at _Debugger+0x10 ldmdb r11, { r11, r13, r15 }
> > db>
> 
> Could you type trace at this point?  (that's if you're loading the symbol
> table from the bootloader)  I think it would help ppl see where the
> problem is.  If I remember it's requested that any kernel problems have a
> trace included (or it used to be).

Do you need the whole trace output ?

It seems to me, that the card *must* be initialized under riscos, either by 
the rom intern network software (ROS 3.6) or by the ANT Internet Suite.

I'll check this again ...

Ciao, Peter.