Re: agr(4) on evbarm

[Paul Goyette <paul%whooppee.com@localhost>]

If you just want to test it, you can add

	if_agr

to /etc/modules.conf

The modules will be loaded early in start-up, long before securelevel
is raised to prevent further loads.


On Fri, 3 Jan 2020, Frédéric Fauberteau wrote:

> Le 2020-01-03 20:54, Jonathan A. Kollasch a écrit :
> > On Fri, Jan 03, 2020 at 08:50:27PM +0100, Frédéric Fauberteau wrote:
> > > I try to aggregate two network interfaces on Raspberry Pi 2 using agr(4).
> > >
> > > # uname -rms
> > > NetBSD 9.99.32 evbarm
> > >
> > > # ifconfig agr0 create
> > > ifconfig: clone_command: Invalid argument
> > > ifconfig: exec_matches: Invalid argument
> > >
> > > Is agr(4) known to be broken on this platform?
> >
> > Doesn't look like evbarm/conf/GENERIC has
> >
> > pseudo-device	agr
> >
> > If it's already a module, it must be loaded before securelevel is
> > raised (which isn't a problem on x86 ports because INSECURE).
>
> I built evbarm/conf/RPI2 and:
> $ grep agr RPI*
> RPI:#pseudo-device      agr                     # IEEE 802.3ad link 
> aggregation
>
> Ok, I have to rebuild.
>
> Thanks!
>
> !DSPAM:5e0f9e0c44021568641052!

+--------------------+--------------------------+-----------------------+
| Paul Goyette       | PGP Key fingerprint:     | E-mail addresses:     |
| (Retired)          | FA29 0E3B 35AF E8AE 6651 | paul%whooppee.com@localhost     |
| Software Developer | 0786 F758 55DE 53BA 7731 | pgoyette%netbsd.org@localhost   |
+--------------------+--------------------------+-----------------------+