Is your unit adequately heat-sinked, adequate air flow, and (especially)
adequate power supply? The power supply is crucial. Also, no
over-clocking, right?
On Mon, Jun 5, 2017 at 5:06 AM, Benjamin Lorenz <mail%benjaminlorenz.com@localhost>
wrote:
On 05 Jun 2017, at 10:13, Benjamin Lorenz <mail%benjaminlorenz.com@localhost> wrote:
Hi, getting crashes like from screenshot below, after quite some uptime
and compilations. Forgot to display backtrace output, after sync the system
unfortunately froze completely.
Got the same crash again, this time after just a couple of minutes of
uptime, on an RPI 2 (last crash was on an RPI 3), and with 8.99.1 earmv7hf.
Did a backtrace, here you go. See screenshot.
Regards,
Benjamin
!DSPAM:5936362b170541839418673!