Re: Kernel crash on Netgear Stora

[William Ross <willspost%googlemail.com@localhost>]

On 6 September 2012 05:51, Masanobu SAITOH <msaitoh%execsw.org@localhost> wrote:
>
>>   Another bug is PR#46898. This bug make a lot of problems...
>
>  This was fixed yesterday and the pullup request for netbsd-6 was sent.
>
> Could you show me a full dmesg of your machine?
>
>

Full dmesg output below. I'll pull current and reinstall after the
weekend and try and stress test it. A bug in gcc means the kernel,
userland and anything compiled from pkgsrc is suspect :(
Thanks for pointing it out though.

ction cache
cpu0: 16KB/32B 4-way write-back-locking-C Data cache
mvsoc0 at mainbus0: Marvell 88F6281 Rev. A1  Kirkwood
mvsoc0: CPU Clock 1000.000 MHz  SysClock 333.333 MHz  TClock 200.000 MHz
mvsoctmr0 at mvsoc0 unit 0 offset 0x20300-0x203ff: Marvell SoC Timer
mvsocgpp0 at mvsoc0 unit 0 offset 0x10100-0x101ff irq 35: Marvell SoC
General Purpose I/O Port Interface
mvsocgpp0: 50 gpio pins
mvsocgpp0: interrupts 96..103, intr 35
mvsocgpp0: interrupts 104..111, intr 36
mvsocgpp0: interrupts 112..119, intr 37
mvsocgpp0: interrupts 120..127, intr 38
mvsocgpp0: interrupts 128..135, intr 39
mvsocgpp0: interrupts 136..143, intr 40
mvsocgpp0: interrupts 144..151, intr 41
mvsocgpp0:   Data Out:                  0x00f00000
mvsocgpp0:   Data Out Enable Control:   0x30000000
mvsocgpp0:   Data Blink Enable:         0x80000000
mvsocgpp0:   Data In Polarity:          0x00000000
mvsocgpp0:   Data In:                   0x30f00000
mvsocgpp0:   Interrupt Cause:           0x80000000
mvsocgpp0:   Interrupt Mask:            0x00000000
mvsocgpp0:   Interrupt Level Mask:      0x00000000
mvsocgpp0:   High Data Out:             0x00000000
mvsocgpp0:   High Data Out Enable Ctrl: 0x00020048
mvsocgpp0:   High Blink Enable:         0x00000001
mvsocgpp0:   High Data In Polarity:     0x00000000
mvsocgpp0:   High Data In:              0x00000041
mvsocgpp0:   High Interrupt Cause:      0x00000001
mvsocgpp0:   High Interrupt Mask:       0x00000000
mvsocgpp0:   High Interrupt Level Mask: 0x00000000
gpio0 at mvsocgpp0: 50 pins
mvsocrtc at mvsoc0 unit 0 not configured
com0 at mvsoc0 unit 0 offset 0x12000-0x1201f irq 33: ns16550a, working fifo
com0: console
com1 at mvsoc0 unit 1 offset 0x12100-0x1211f irq 34: ns16550a, working fifo
ehci0 at mvsoc0 unit 0 offset 0x50000-0x51fff irq 19: Marvell USB 2.0 Interface
ehci0: EHCI version 1.0
usb0 at ehci0: USB revision 2.0
gttwsi0 at mvsoc0 unit 0 offset 0x11000-0x11fff irq 29: Marvell TWSI controller
iic0 at gttwsi0: I2C bus
mvcesa at mvsoc0 unit 0 not configured
mvgbec0 at mvsoc0 unit 0 offset 0x70000-0x73fff: Marvell Gigabit
Ethernet Controller
mvgbe0 at mvgbec0 port 0 irq 11
mvgbe0: Ethernet address c0:3f:0e:b0:e8:8a
makphy0 at mvgbe0 phy 8: Marvell 88E1116R Gigabit PHY, rev. 0
makphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseT,
1000baseT-FDX, auto
mvgbec1 at mvsoc0 unit 1 offset 0x74000-0x77fff: Marvell Gigabit
Ethernet Controller
mvgbe1 at mvgbec1 port 0 irq 15
mvgbe1: Ethernet address 00:50:43:00:02:02
mvgbe1: no PHY found!
mvpex0 at mvsoc0 unit 0 offset 0x40000-0x41fff irq 9: Marvell PCI
Express Interface
pci0 at mvpex0
pci0: i/o space, memory space enabled
Marvell 88F6281 SoC Kirkwood (miscellaneous memory, revision 0x03) at
pci0 dev 0 function 0 not configured
mvsata0 at mvsoc0 unit 0 offset 0x80000-0x87fff irq 21: Marvell
Serial-ATA Host Controller (SATAHC)
mvsata0: GenIIe, 1hc, 2port/hc
atabus0 at mvsata0 channel 0
atabus1 at mvsata0 channel 1
mvsdio at mvsoc0 unit 0 not configured
timecounter: Timecounter "clockinterrupt" frequency 100 Hz quality 0
timecounter: Timecounter "mvsoctmr0" frequency 200000000 Hz quality 100
uhub0 at usb0: Marvell EHCI root hub, class 9/0, rev 2.00/1.00, addr 1
uhub0: 1 port with 1 removable, self powered
mvsata0 port 0: device present, speed: 3.0Gb/s
wd0 at atabus0 drive 0
wd0: <Hitachi HDS5C3020ALA632>
wd0: drive supports 16-sector PIO transfers, LBA48 addressing
wd0: 1863 GB, 3876021 cyl, 16 head, 63 sec, 512 bytes/sect x 3907029168 sectors
wd0: drive supports PIO mode 4, DMA mode 2, Ultra-DMA mode 6 (Ultra/133)
wd0(mvsata0:0:0): using PIO mode 4, Ultra-DMA mode 6 (Ultra/133) (using DMA)
Kernelized RAIDframe activated
raid0: RAID Level 1
raid0: Components: /dev/wd0a component1[**FAILED**]
raid0: Total Sectors: 3907028992 (1907729 MB)
boot device: raid0
root on raid0a dumps on raid0b
/: replaying log to memory
root file system type: ffs
WARNING: no TOD clock present
WARNING: using filesystem time
WARNING: CHECK AND RESET THE DATE!
/: replaying log to disk
/var: replaying log to disk
/tmp: replaying log to disk
raid0: Error re-writing parity (1)!