On Sun, Nov 28, 1999 at 10:35:21PM +0200, François-Xavier D'Hollander wrote:
> Hello Ignatios
> 
> Le 27-Nov-99, Ignatios Souvatzis a écrit:
> 
> >> oh, it's a french modem connected on serial port. nothing to do with
> >> Amiga. This modem have self memory to do fax, email, answer machine
> >> without the computer switchs on.
> > 
> > Then it is innocent, I guess. Unless it sends a BREAK signal to the
> > machine, which might bring the machine into the kernel debugger for the
> > serial console for the brief moment the serial is the console (until the
> > proper grf device has been decided upon).
> > 
> > I suggest that you try, just once, without it.
> > 
> >> PROCESSOR:    CPU 68040/68040fpu
> >> CUSTOM CHIPS:    AA PAL Alice (id=$0023), AA Lisa (id=$00F8)
> >> VERS:    Kickstart version 40.68, Exec version 40.10, Disk version 40.42
> >> RAM:    Node type $A, Attributes $505 (FAST), at $7000000-$7FFFFFF (16.0
> >> meg)
> >>     Node type $A, Attributes $605 (FAST), at $200000-$7FFFFF (6.0 meg)
> > 
> > Zorro II memory, huh? (I guess on the GVP board(s)?)
> > Boot without this.  The parameter is -n0.
> 
> don't work. same behavior than explained after.
> 
> >>    Node type $A, Attributes $703 (CHIP), at $1000-$1FFFFF (~2.0 meg)
> >> BOARDS:
> >> Board + ROM (HD?) (unidentified):   Prod=2167/24($877/$18)
> >>     (@$40000000, size 32meg, subsize same)
> >> Board + ROM (HD?) (unidentified):   Prod=2017/11($7E1/$B) (@$E90000 64K)
> >> RAM (unidentified):   Prod=2017/10($7E1/$A) (@$200000 4meg Mem)
> >> RAM (unidentified):   Prod=2017/10($7E1/$A) (@$600000 2meg Mem)
> > 
> > The GVP memory.
> > 
> >>  Board + ROM (HD?) (unidentified):   Prod=2206/25($89E/$19)
> >>      (@$42000000, size 16meg, subsize same)
> > What is this?
> 
> My new Fast ata friver from Elbox. But I use only my internal ide for
> netbsd.
> 
> But the most strange thing is now:
> netbsd boots only when I have my FastATA connected. When I deconnect it,
> loadbsd freezes. No grey screen this times.
> 
> 
> Now, with my Fast ATA connected. If don't launch the WB (boot without
> startup-sequence), I have the grey screen. If launch the wb, netbsd boots
> right.
> I done test with 68040.library from Phase5 and from MMULib (on aminet).

this sounds as if the 68040.library was not installed! Can you check this?

	-is