>>>>> Miles Nordin writes:

Miles> but on the DS10, SCSI only. :(

FWIW, I bought a cheap SATA-controller and put a 160GB SATA disk in my
old PWS 500au. It works perfectly (and with very good performance on
this old system).

Best regards,
     -- Urban

satalink0 at pci2 dev 10 function 0
satalink0: Silicon Image SATALink 3112 (rev. 0x02)
satalink0: SATALink BA5 register space disabled
satalink0: bus-master DMA support present
satalink0: primary channel wired to native-PCI mode
satalink0: using dec 550 irq 20 for native-PCI interrupt
atabus2 at satalink0 channel 0
satalink0: secondary channel wired to native-PCI mode
atabus3 at satalink0 channel 1
satalink0: port 0: device present, speed: 1.5Gb/s
wd0 at atabus2 drive 0: <ST3160827AS>
wd0: drive supports 16-sector PIO transfers, LBA48 addressing
wd0: 149 GB, 310101 cyl, 16 head, 63 sec, 512 bytes/sect x 312581808 sectors
wd0: 32-bit data port
wd0: drive supports PIO mode 4, DMA mode 2, Ultra-DMA mode 6 (Ultra/133)
wd0(satalink0:0:0): using PIO mode 4, Ultra-DMA mode 6 (Ultra/133) (using DMA)