I told Peter to try putting it into a PC and see what the NVRAM settings were-
it said "invalid NVRAM settings".. Do you happen to know whether if you take
the standard QLogic flash utility the re-initializes NVRAm whether SRM is okay
with that? Or is there a tool in SRM to fix NVRAM?

-matt


On Wed, 3 Oct 2001, Wilko Bulte wrote:

> On Wed, Oct 03, 2001 at 12:48:12PM -0500, Peter Seebach wrote:
> > Now I'm stumped.  Matt Jacob sent me a Qlogic board to try.  It works
> > fine; SRM sees it.
> > 
> > It is almost totally identical to the Qlogic board I was trying that didn't
> > work.
> > 
> > Mine:			His:
> > Qlogic			Qlogic
> > ISP1040B 2405101	ISP 1040B 2405101
> > MIQL42/N0105D		MIKL8U/N9750D
> > 
> > Both have 60Mhz crystals, and a chip with a sticker on it saying "AA67A".
> > 
> > Mine says "PC2010403-09 K", his says "PC2010403-11-E", in the "assembly/rev"
> > section.
> > 
> > With his, "show config" says
> >      Bus 00  Slot 09: QLogic ISP1020 Scsi Controller
> >                                    pka0.7.0.9.0          SCSI Bus ID 7
> >                                    dka0.0.0.9.0           SEAGATE ST34501W
> > With mine, it says:
> >      Bus 00  Slot 09: QLogic ISP1020 Scsi Controller
> 
> So SRM sees it. The card itself just does not see SCSI devices. Could be
> a dead board. Dead on the SCSI side of things.
> 
> > !@!#@*!@#*.
> 
> Tja...
> 
> -- 
> |   / o / /_  _   		email: 	wilko@FreeBSD.org
> |/|/ / / /(  (_)  Bulte		Arnhem, The Netherlands	
>