On Mon, Jan 08, 2001 at 11:19:11PM +0100, Istvan Gyenes wrote:
> 
> ----- Original Message -----
> From: "Duane Eddingfield" <deddingf@home.com>
> To: <port-alpha@netbsd.org>
> Sent: Sunday, December 24, 2000 2:39 AM
> Subject: Trying to install 1.5 on the Jensen
> 
> >     The last lines on the terminal after "boot dka0" are:
> >         ...
> >         lpt0: interrupting at eisa irq 1
> >         mcclock0 at jensenio0 port 0x170: mc146818 or compatible
> >         eisa0 at jensenio0
> >         fatal kernel trap:
> >
> >             trap entry = 0x2 (memory management fault)
> >             ...
> >         Stopped in swapper at ...
> >
> >     Interestingly, I have a Jensen clone with 32 MB RAM but with 1742A
> > REV E which actually boots
> > the same image just fine upto detecting the floppy drive and then hangs.
> > I am assuming this is because
> > of the older firmware on the 1742A..
> 
> I don't think so. I think it more depends on what kind of EISA cards you
> have.
> I have 2 Jensens, one of them is a "full" one (DE425,QVision,AHA1742A) the
> other
> only has an AHA1742A and doesn't have other EISA cards.
> Both of the SCSI controllers have rev G.2 eprom. The first ("full") one
> crashes at boot with a fatal
> kernel trap (at least it crashed the last time I tried), the second one
> hangs with a floppy timeout.
> I don't know if it's EISA card dependent or not, but it looks like.

Is the EISA config identically configured using the ECU? Just a wild guess..

-- 
|   / o / /  _  	 Arnhem, The Netherlands    	email: wilko@freebsd.org
|/|/ / / /( (_) Bulte	 http://www.freebsd.org 	http://www.nlfug.nl