On Fri, Jul 14, 2000 at 04:56:09PM -0500, Mike Stone wrote:

 > >>>show config
 > 
 > Firmware
 > SRM Console:    V3.1-2
 > ARC Console:    4.44
 > PALcode:        VMS PALcode V5.53-5, OSF PALcode V1.46-1
 > Serial Rom:     V2.8

Ok, from the output here, it seems to indicate that there is NOT
a PCI graphics card installed in the system.  Is that correct?

In other words, you are using a serial console?

 > 
 > Processor
 > DECchip (tm) 21064A-6    266Mhz
 > 
 > MEMORY
 >      128 Meg of System Memory
 >      Bank 0 = 64 Mbytes() Starting at 0x00000000
 >      Bank 1 = 64 Mbytes() Starting at 0x04000000
 > 
 > PCI Bus
 >      Bus 00  Slot 06: NCR     810 Scsi Controller
 >                                    pka0.7.0.6.0          SCSI Bus ID 7
 >                                    dka400.4.0.6.0         RRD45
 > 
 >      Bus 00  Slot 07: Intel   8275EB PCI to Eisa Bridge
 > 
 > 
 >      Bus 00  Slot 11: DECchip 21040 Network Controller
 >                                    ewa0.0.0.11.0         00-00-F8-21-D9-93
 > 
 >      Bus 00  Slot 12: DAC960  Scsi Raid Controller
 >                                    dra.0.0.12.0
 >                                    dra0.0.0.12.0          2 Member RAID 1
 > 
 > 
 > EISA Bus Modules (installed)
 > >>>show dev
 > dka400.4.0.6.0            DKA400                         RRD45  1645
 > dra0.0.0.12.0             DRA0                 2 Member RAID 1
 > dva0.0.0.0.1              DVA0
 > ewa0.0.0.11.0             EWA0               00-00-F8-21-D9-93
 > pka0.7.0.6.0              PKA0                   SCSI Bus ID 7
 > >>>
 > 
 > 
 > 
 > 
 > hope it means more to you than it does to me.  ;-)
 > 
 > 
 > thanks,
 > 
 > mike stone
 > .
 > 
 > 
 > 
 > 
 > 

-- 
        -- Jason R. Thorpe <thorpej@zembu.com>