Greg Oster wrote:
> There will almost always be complaints about hosed components and 
> what-not when doing an initial configuration -- the "-C" option says
> "ignore those errors and configure anyway".
> 
> 
>>next initialization steps I didn't make,
>>because I think, it was unnecessary to gone ahead..
> 
> 
> If you continue on and do the "-I" step, I think you'll find things 
> are working just fine. 

I did that, but it isn't fine..
here is output from messages:

Sep  9 17:22:38  /netbsd: raid0: IO Error.  Marking /dev/wd3a as failed.
Sep  9 17:22:38  /netbsd: Unable to correct parity in VerifyParity: 
can't write the stripe
Sep  9 17:22:38  /netbsd: Could not correct bad parity
Sep  9 17:22:38  /netbsd: raid0: Error re-writing parity!
Sep  9 17:23:19  /netbsd: raid0: WARNING: raid0: total sector size in 
disklabel (241254720) != the size of raid (482509312)

any ideas?

/when I ran raidctl -iv after that, it just appear on screen and go away
in few second../

thx.
-- 

   >>  jabber: ado@njs.netlab.cz   <<
   >>  e-mail: ado@nirvanaclub.sk  <<
----------------------------------------
// just visit> http://www.nirvanaclub.sk