I noticed in my dmesg that I still had a USB hub unconfigured.
I configured the internal hub then the USBHID stuff and recompiled
the new kernel. BOTH WERE SUCCESSFULL.

So I installed the second kernel and booted that. Right after it
found the cd, it hung for a few seconds, the lights on the gamepad
game on, it then went on with the rest of the boot sequence.

Here are the 2 relevant parts of the dmesg:


pcib0 at pci0 dev 7 function 0
pcib0: VIA Technologies VT82C686A (Apollo KX133) PCI-ISA Bridge (rev. 0x40)
VIA Technologies VT82C586A IDE Controller (IDE mass storage, interface 0x8a, revision 0x06) at pci0 dev 7 function 1 not configured
uhci0 at pci0 dev 7 function 2: VIA Technologies VT83C572 USB Controller (rev. 0x16)
uhci0: interrupting at irq 5
usb0 at uhci0: USB revision 1.0
uhub0 at usb0
uhub0: VIA Technologie UHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub0: 2 ports with 2 removable, self powered
uhci1 at pci0 dev 7 function 3: VIA Technologies VT83C572 USB Controller (rev. 0x16)
uhci1: interrupting at irq 5
usb1 at uhci1: USB revision 1.0
uhub1 at usb1
uhub1: VIA Technologie UHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub1: 2 ports with 2 removable, self powered
viapm0 at pci0 dev 7 function 4
viaenv0 at viapm0

     .
     .
     .
cd0 at scsibus1 target 4 lun 0: <NEC, CD-ROM DRIVE:463, 1.05> SCSI2 5/cdrom removable
cd0: sync (100.0ns offset 15), 8-bit (10.000MB/s) transfers
uhub1: port 2, set config at addr 2 failed
uhub1: device problem, disabling port 2
boot device: sd0
root on sd0a dumps on sd0b
root file system type: ffs
IP Filter: v3.4.27 initialized.  Default = pass all, Logging = enabled
uhub1: port error, restarting port 2
uhub1: device problem, disabling port 2

Any takers?




-- 
__________________________________________________________
Sign-up for your own FREE Personalized E-mail at Mail.com
http://www.mail.com/?sr=signup