On Mon, Sep 12, 2005 at 08:37:03PM -0400, Robert Ken Francis wrote:
> I just got NetBSD 3.99.8 and it still has the same problem 2.0.2 has, which is that I always get a "hptide0:0: bogus intr" message
> in my dmesg (see below).  I am running an Adaptec ATA RAID 1200A card.  The hard drive is an old Conner CP3041 and is a slave drive
> on the first Adaptec IDE ribbon.

Note that this is not a supported configuration. The ATA drafts clearly says
that a slave ATA device without master has undefined behavior.

Otherwise these "bogus intr" should not be much of a problem if you can
use the drive.

-- 
Manuel Bouyer <bouyer@antioche.eu.org>
     NetBSD: 26 ans d'experience feront toujours la difference
--