No, my laptop (COMPAQ Presario 1200 XL103) is a little too old !! it's no
longer commercialized.
So I think it's a "real" modem, because I'm so curious and I've taken
apart my laptop, and the Lucent modem look like present, with the Lucent
chip 1646T00  REA 12V  0001S 4185474.
By the way, it's not a PC Card modem, my modem is connected to my mother
card. And under FreeBSD 5.0, my modem is NOT detected, but under "windows
98se", it's detected. I've not tested under Linux.





> On Tue, Nov 18, 2003 at 07:27:27PM +0100, frederic.nivor@iedparis8.net
> wrote:
>
>> hi, i have a laptop COMPAQ Presario 1200 xl103, and my dmesg with
>> netbsd1.6.1 look like this:
>> Lucent Technologies LT Modem (miscellaneous communications, revision
>> 0x01) at pci0 dev 9 function 0 not configured
>
> not configured means the kernel has no code
> to handle it. sadly, as most laptop modems
> are "soft modems" (to lower their price,
> they have no digital to audio encoder,
> this work is left to the cpu which raises
> its load as modem use grows) and very, very
> often we have no source for them.
>
> you can try to check if there's linux
> support for your modem and port the code.
> i got a lucent modem and ibm did put out
> a linux driver; if there's a linux driver
> there's good hope it can be made to work
> but mot sure.
>
>> Then, I have an other problem in my dmesg:
>> VIA Technologies VT82C686A SMBus Controller (ISA bridge, revision
>> 0x20) at pc0 dev 7 function 4 not configured
>> Texas Instruments PCI1211 PCI-CardBus Bridge (CardBus bridge) at pci0
>> dev 10 function 0 not configured
>
> this is not, per se, a problem. i got a
> smbus too and i've been working on code
> to get mine supported (i use a thinkpad
> x30 model). the smbus is an intel variant
> of a 2-wire simple bus developped by
> philipps. what is usually found on the
> smbus is thermal sensor and, sometimes,
> infrared device. once i'll be able to poll
> what's on the smbus i'll know what's on
> mine but i'm still reading sources to find
> how i can implement an ioctl i would call
> from userland.
>
>> And with an other laptop, HP OmniBook 7100, I have this dmesg:
>> Texas Instruments PCI1250 PCI-CardBus Bridge (CardBus bridge revision
>> 0x02) at pci0 dev4 function 0 not configured
>> same with    function 1 not configured
>
> check which kernel you are running. look
> in /usr/src/sys/i386/conf and verify if
> your kernel has some cardbus lines commented
> out (that was the case for two cardbus lines
> on some previous kernels 1.6 or before).
>
>> Intel 82371AB Power Management Controller (PIIX4) (miscellaneous
>> bridge, revision 0x02) at pci0 dev 7 function 3 not configured
>
> compile a new kernel with apm
> (just cp GENERIC to something like MOOMOO and
> edit it so the apm line no longer starts
> with a #) - there are docs that explain how
> to compile kernels.
>
> check your "man options" too.
>
> and last: have your mailer cut lines at 72
> chars or 80 _please_ (:
>
> --
> Gilbert Fernandes