--ZY5CS28jBCfb727c
Content-Type: text/plain; charset=us-ascii
Content-Disposition: inline
Content-Transfer-Encoding: quoted-printable

On Wed, Jun 18, 2003 at 08:36:22PM +0000, Valeriy E. Ushakov wrote:
> Siegmund Fuhringer <sifu@0xx0.net> wrote:
>=20
> > so i need a pci-pcmcia bridge, but there are so many available and i
> > don't know which one can be used with an d-link dwl 660, has netbsd
> > support and is cheap.
>=20
> This is what I use:
>=20
> cbb0 at pci0 dev 18 function 0: Texas Instruments PCI1410 PCI-CardBus Bri=
dge (rev. 0x01)
> cbb0: interrupting at irq 10
> cardslot0 at cbb0 slot 0 flags 0
> cardbus0 at cardslot0: bus 1 device 0
> pcmcia0 at cardslot0
> wi0 at pcmcia0 function 0: Lucent Technologies, WaveLAN/IEEE, Version 01.=
01
>=20


> Check sys/dev/pci/pccbb.c for a list of supported pci-cardbus bridges.

this made my decision a lot easier.


>=20
> Chances are you'll need some of:
>=20
> options PCIBIOS
> options PCIBIOS_ADDR_FIXUP
> options PCIBIOS_BUS_FIXUP
> options PCIBIOS_INTR_FIXUP

good to know :)


>=20
> I never bothered to check if PCIBIOS and PCIBIOS_INTR_FIXUP are enough
> to get the interrupt for the bridge (the box was set up in a hurry).
>=20
> PS: No idea about DWL-660, or how cheap this bridge was ;)

i will try the EPoX EWL-PCA bridge...


thank you - sifu

>=20
> SY, Uwe
> --=20
> uwe@ptc.spbu.ru                         |       Zu Grunde kommen
> http://www.ptc.spbu.ru/~uwe/            |       Ist zu Grunde gehen
>=20

--ZY5CS28jBCfb727c
Content-Type: application/pgp-signature
Content-Disposition: inline

-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.2.1 (FreeBSD)

iD8DBQE+8XIWi6ACRCFwm4IRApNyAKCXDVP/sjEqb/LkeI0eQATtNCLSSQCgsoXd
wZ7RjPycER6cpkJVoRCuNeo=
=lTwm
-----END PGP SIGNATURE-----

--ZY5CS28jBCfb727c--