On Wed, 22 Dec 1999, Zach Fine wrote:

> Can anyone help me with this one? Does it mean that there is some sort 
> of hardware conflict with my secondary IDE controller or is it a disk
> error?
> 
> Thanks.
> -Zach Fine
> czyz@serv.net
> 
> 
> pciide0:1:1: lost interrupt
>         type: ata
>         c_bcount: 8192
>         c_skip: 0
> pciide0:1:1: Bus-Master DMA error: missing interrupt, status=0x61
> wd2e: device fault writing fsbn 6532224 of 6532224-6532239 (wd2 bn 7100736; cn 7044 tn 6 sn 6), retrying
> wd2: soft error (corrected)

I used to get these quite a bit when I was running 1.3.x (with or without
the IDE patches installed). However, since upgrading to 1.4, and then
on to 1.4.1, I have yet to see these. If you are running 1.3.x, you should
consider upgrading.


Brian

-------------------------------------------------------------------------
| Brian Stark                       | Internet : bstark@siemens-psc.com |
| Siemens PT&D, Inc.                | Voice    : +1 612 536-4697        |
| Power Systems Control Division    | Fax      : +1 612 536-4919        |
| 7225 Northland Drive, Brooklyn Park, Minnesota 55428   USA            | 
-------------------------------------------------------------------------