Worst case would be to make a bootable floppy with the config
	util on (I did this way back)

		David/abs

    "Its a bright sunny california day outside, and you're inside."
    "And your point would be...?"


On Tue, 22 Jul 1997, Brook Milligan wrote:

> I am trying to convert a 3com etherlink III card (ep driver) from
> using the 10base-T connector to using the BNC connector.  The man page
> for ep(4i386) says that the card must be switched using the 3com dos
> configuration utility.  However, the documentation says (and the apparent
> behavior confirms) that that utility requires a dos disk do work.
> 
> Problem:  I have no dos partition on the relevant machine.  Is there
> any netbsd software that will do the same thing or do I have to tear
> into the box and swap cards around?
> 
> Cheers,
> Brook
>