Hello Sean,

> I have two Intel boxes running NetBSD 1.2.1 acting as file servers.
> The boxes have the same setup with an ATX motherboard, EM960 ethernet
> card and two SCSI controlers.
> 
> One of the SCSI controlers is an Adaptec 2940 and has the Root disk
> (A segate ST-51080N 1gig) and a HP DDS 3 dat drive. I use the segate's
> termination options to terminate the end of the 50 way IDC used for
> the internal SCSI bus the dat drive is connected to an IDC connector
> about 2 inches before the end connector.

SCSI specs say you should have at least 6 inches between the connectors. I
hat a lot of trouble due to connectors too near to each other. And just to
make shure: There is a device connected to the last connector isn't there?
Loose ends are even worse.

Oliver.

==========================================================================
Oliver Bruckauf                            http://www.poboxes.com/bruckauf
                                               email: bruckauf@poboxes.com
TeamOS/2 Germany (#540)                                  Fido: 2:2448/1414
Words to the Wise:      Air conditioned environment - Do not open Windows.
==========================================================================