port-arm/48130: With earm MARVEL_NAS kernel, /sbin/init exits with panic: init died (signal 0, exit 11)

To: port-arm-maintainer%netbsd.org@localhost,gnats-admin%netbsd.org@localhost,netbsd-bugs%netbsd.org@localhost
Subject: port-arm/48130: With earm MARVEL_NAS kernel, /sbin/init exits with panic: init died (signal 0, exit 11)
From: ryoon%NetBSD.org@localhost
Date: Fri, 16 Aug 2013 18:30:00 +0000 (UTC)
>Number:         48130
>Category:       port-arm
>Synopsis:       With earm MARVEL_NAS kernel, /sbin/init exits with panic: init 
>died (signal 0, exit 11)
>Confidential:   no
>Severity:       serious
>Priority:       medium
>Responsible:    port-arm-maintainer
>State:          open
>Class:          sw-bug
>Submitter-Id:   net
>Arrival-Date:   Fri Aug 16 18:30:00 +0000 2013
>Originator:     Ryo ONODERA
>Release:        NetBSD 6.99.23
>Organization:
        
>Environment:
        
        
System: NetBSD tellurium.elements.tetera.org 6.99.23 NetBSD 6.99.23 (DTRACE) 
#2: Thu Aug 8 10:01:27 JST 2013 
ryo_on%tellurium.elements.tetera.org@localhost:/usr/obj/amd64/sys/arch/amd64/compile/DTRACE
 amd64
Architecture: x86_64
Machine: amd64
>Description:
MARVELL_NAS kernel of NetBSD/evbearm-el current of 2013-08-16 does not boot.
/sbin/init exits with "panic: init died (signal 0, exit 11)" message.

         __  __                      _ _
        |  \/  | __ _ _ ____   _____| | |
        | |\/| |/ _` | '__\ \ / / _ \ | |
        | |  | | (_| | |   \ V /  __/ | |
        |_|  |_|\__,_|_|    \_/ \___|_|_|
 _   _     ____              _
| | | |   | __ )  ___   ___ | |_
| | | |___|  _ \ / _ \ / _ \| __|
| |_| |___| |_) | (_) | (_) | |_
 \___/    |____/ \___/ \___/ \__|  ** LOADER **
 ** MARVELL BOARD: DB-88F6281A-BP LE

U-Boot 1.1.4 (Apr 23 2009 - 19:01:28) Marvell version: 3.4.4

U-Boot code: 00600000 -> 0067FFF0  BSS: -> 00690DCC

Soc: MV88F6281 Rev 3 (DDR2)
CPU running @ 800Mhz L2 running @ 400Mhz
SysClock = 400Mhz , TClock = 200Mhz

DRAM CAS Latency = 5 tRP = 5 tRAS = 18 tRCD=6
DRAM CS[0] base 0x00000000   size 256MB
DRAM Total size 256MB  16bit width
[16384kB@f8000000] Flash: 16 MB
Addresses 8M - 0M are saved for the U-Boot usage.
Mem malloc Initialization (8M - 7M): Done
*** Warning - bad CRC, using default environment


CPU : Marvell Feroceon (Rev 1)

Streaming disabled
Write allocate disabled


USB 0: host mode
PEX 0: interface detected no Link.
Net:   egiga0 [PRIME]
Hit any key to stop autoboot:  0
QNAP: Recovery Button pressed: 0
Marvell>> setenv serverip 192.168.81.249
Marvell>> setenv ipaddr 192.168.81.127
Marvell>> tftp 0x800000 netbsd.ub
Using egiga0 device
TFTP from server 192.168.81.249; our IP address is 192.168.81.127
Filename 'netbsd.ub'.
Load address: 0x800000
Loading: #################################################################
         #################################################################
         #################################################################
         #################################################################
         #################################################################
         #################################################################
         #################################################################
         #################################################################
         #################################################################
         #################################################################
         #################################################################
         #################################################################
         ###########################################################
done
Bytes transferred = 4293568 (4183c0 hex)
Marvell>> bootm
## Booting image at 00800000 ...
   Image Name:   NetBSD/ 6.99.23
   Created:      2013-08-16  17:02:09 UTC
   Image Type:   ARM NetBSD Kernel Image (uncompressed)
   Data Size:    4293504 Bytes =  4.1 MB
   Load Address: 00008000
   Entry Point:  00008000
   Verifying Checksum ... OK
OK
## Transferring control to NetBSD stage-2 loader (at address 00008000) ...

NetBSD/evbarm (Marvell) booting ...
Copyright (c) 1996, 1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005,
    2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013
    The NetBSD Foundation, Inc.  All rights reserved.
Copyright (c) 1982, 1986, 1989, 1991, 1993
    The Regents of the University of California.  All rights reserved.

NetBSD 6.99.23 (MARVELL_NAS) #1: Sat Aug 17 02:02:08 JST 2013
        
ryo_on%tellurium.elements.tetera.org@localhost:/usr/obj/evbearm/sys/arch/evbarm/compile/MARVELL_NAS
total memory = 256 MB
avail memory = 246 MB
mainbus0 (root)
cpu0 at mainbus0 core 0: Sheeva 88SV131 rev 1 (ARM9E-S V5TE core)
cpu0: DC enabled IC enabled WB enabled EABT branch prediction enabled
cpu0: 16KB/32B 4-way L1 Instruction cache
cpu0: 16KB/32B 4-way write-back-locking-C L1 Data cache
mvsoc0 at mainbus0: Marvell 88F6281 Rev. A1  Kirkwood
mvsoc0: CPU Clock 800.000 MHz  SysClock 400.000 MHz  TClock 200.000 MHz
mvsoctmr0 at mvsoc0 unit 0 offset 0x20300-0x203ff: Marvell SoC Timer
mvsocgpp0 at mvsoc0 unit 0 offset 0x10100-0x101ff irq 35: Marvell SoC General 
Purpose I/O Port Interface
mvsocgpp0: 50 gpio pins
mvsocgpp0: interrupts 96..103, intr 35
mvsocgpp0: interrupts 104..111, intr 36
mvsocgpp0: interrupts 112..119, intr 37
mvsocgpp0: interrupts 120..127, intr 38
mvsocgpp0: interrupts 128..135, intr 39
mvsocgpp0: interrupts 136..143, intr 40
mvsocgpp0: interrupts 144..151, intr 41
mvsocgpp0:   Data Out:                  0x00000000
mvsocgpp0:   Data Out Enable Control:   0x00012000
mvsocgpp0:   Data Blink Enable:         0x00000000
mvsocgpp0:   Data In Polarity:          0x00000000
mvsocgpp0:   Data In:                   0x00010000
mvsocgpp0:   Interrupt Cause:           0x00000000
mvsocgpp0:   Interrupt Mask:            0x00000000
mvsocgpp0:   Interrupt Level Mask:      0x00000000
mvsocgpp0:   High Data Out:             0x0000000c
mvsocgpp0:   High Data Out Enable Ctrl: 0xffffffd3
mvsocgpp0:   High Blink Enable:         0x00000000
mvsocgpp0:   High Data In Polarity:     0x00000000
mvsocgpp0:   High Data In:              0x0000004c
mvsocgpp0:   High Interrupt Cause:      0x00000000
mvsocgpp0:   High Interrupt Mask:       0x00000000
mvsocgpp0:   High Interrupt Level Mask: 0x00000000
gpio0 at mvsocgpp0: 50 pins
mvsocrtc at mvsoc0 unit 0 not configured
com0 at mvsoc0 unit 0 offset 0x12000-0x1201f irq 33: ns16550a, working fifo
com0: console
com1 at mvsoc0 unit 1 offset 0x12100-0x1211f irq 34: ns16550a, working fifo
ehci0 at mvsoc0 unit 0 offset 0x50000-0x51fff irq 19: Marvell USB 2.0 Interface
usb0 at ehci0: USB revision 2.0
gtidmac0 at mvsoc0 unit 0 offset 0x60000-0x60fff: Marvell IDMA Controller/XOR 
Engine
gtidmac0: XOR Engine 4 channels, intr 5...8
gttwsi0 at mvsoc0 unit 0 offset 0x11000-0x110ff irq 29: Marvell TWSI controller
iic0 at gttwsi0: I2C bus
mvcesa0 at mvsoc0 unit 0 offset 0x30000-0x3ffff irq 22: Marvell Cryptographic 
Engines and Security Accelerator
mvgbec0 at mvsoc0 unit 0 offset 0x70000-0x73fff: Marvell Gigabit Ethernet 
Controller
mvgbe0 at mvgbec0 port 0 irq 11
mvgbe0: Ethernet address 00:50:43:3c:3b:5d
makphy0 at mvgbe0 phy 8: Marvell 88E1116R Gigabit PHY, rev. 0
makphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseT, 
1000baseT-FDX, auto
mvsoc0: mvgbec1 clock disabled
mvpex0 at mvsoc0 unit 0 offset 0x40000-0x41fff irq 9: Marvell PCI Express 
Interface
pci0 at mvpex0
Marvell 88F6281 SoC Kirkwood (miscellaneous memory, revision 0x03) at pci0 dev 
0 function 0 not configured
mvsata0 at mvsoc0 unit 0 offset 0x80000-0x87fff irq 21: Marvell Serial-ATA Host 
Controller (SATAHC)
mvsata0: GenIIe, 1hc, 2port/hc
atabus0 at mvsata0 channel 0
atabus1 at mvsata0 channel 1
mvsdio at mvsoc0 unit 0 not configured
uhub0 at usb0: Marvell EHCI root hub, class 9/0, rev 2.00/1.00, addr 1
mvsata0 port 0: device present, speed: 3.0Gb/s
wd0 at atabus0 drive 0
wd0: <WDC WD20EARS-00MVWB0>
wd0: 1863 GB, 3876021 cyl, 16 head, 63 sec, 512 bytes/sect x 3907029168 sectors
uhub1 at uhub0 port 1: Genesys Logic USB2.0 Hub, class 9/0, rev 2.00/77.60, 
addr 2
uhub1: single transaction translator
boot device: <unknown>
root device: mvgbe0
dump device:
file system (default generic):
root on mvgbe0
nfs_boot: trying DHCP/BOOTP
nfs_boot: DHCP next-server: 192.168.81.249
nfs_boot: my_domain=elements.tetera.org
nfs_boot: my_addr=192.168.81.127
nfs_boot: my_mask=255.255.255.0
nfs_boot: gateway=192.168.81.1
root on 192.168.81.249:/exports/ts110
root file system type: nfs
WARNING: no TOD clock present
WARNING: using filesystem time
WARNING: CHECK AND RESET THE DATE!
warning: no /dev/console
init path (default /sbin/init):
init: trying /sbin/init
panic: init died (signal 0, exit 11)
rebooting...


        
>How-To-Repeat:
See above.
        
>Fix:
        
I have no idea.

>Unformatted:
Prev by Date: port-arm/48129: build.sh -m -m evbearm-el -u release fails
Next by Date: NetBSD Nightly Trouble Ticket Report
Previous by Thread: port-arm/48129: build.sh -m -m evbearm-el -u release fails
Next by Thread: Re: port-arm/48130: With earm MARVEL_NAS kernel, /sbin/init exits with panic: init died (signal 0, exit 11)
Indexes:
Home | Main Index | Thread Index | Old Index