The following reply was made to PR install/32577; it has been noted by GNATS.

From: cadavre@chatsa.co.za
To: gnats-bugs@netbsd.org
Cc: 
Subject: Re: install/32577
Date: Fri, 20 Jan 2006 14:10:54 +0200 (SAST)

 agp at pchb0 not configured
 ATI Technologies product 0x4363 (SMBus serial bus, revision 0x03) at pci0
 dev 20 function 0 not configured
 
 After performing a temporary installation of NetBSD 3.0 on a lower
 capacity IDE drive, no reference was made to the SIL controller when
 viewing the ouput from dmesg. I have however included the lines for the
 IXP IDE Controller below.
 
 
 ATI Technologies product 0x4363 (SMBus serial bus, revision 0x03) at pci0
 dev 20 function 0 not configured
 ixpide0 at pci0 dev 20 function 1
 ixpide0: ATI Technologies IXP IDE Controller (rev. 0x01)
 ixpide0: bus-master DMA support present
 ixpide0: primary channel configured to compatibility mode
 ixpide0: primary channel interrupting at irq 14
 atabus0 at ixpide0 channel 0
 ixpide0: secondary channel configured to compatibility mode
 ixpide0: secondary channel interrupting at irq 15
 atabus1 at ixpide0 channel 1
 
 Your support is greatly appreciated.