Subject: kern/30851: bge breaks ipnat
To: None <firstname.lastname@example.org, email@example.com,>
From: None <firstname.lastname@example.org>
Date: 07/27/2005 18:32:00
>Synopsis: bad NAT with bge
>Arrival-Date: Wed Jul 27 18:32:00 +0000 2005
>Originator: Patrick Welche
>Release: NetBSD 3.99.7
cvs of 20 July 2005 11:12 UTC
When bge(4) is the external interface on which an ipnat mapping is defined,
the return packets are blocked because of "bad NAT" as they don't match
the state table.
Rather like in kern/29660, though this is a different Dell GX280, find a
computer with a
bge0 at pci2 dev 0 function 0: Broadcom BCM5751 Gigabit Ethernet
bge0: interrupting at irq 11
bge0: ASIC BCM5750 A1 (0x4001), Ethernet address 00:11:43:7c:6c:94
brgphy0 at bge0 phy 1: BCM5750 1000BASE-T media interface, rev. 0
brgphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseT, 1000baseT-FDX, auto
and some other network card, eg. ex.
map bge0 192.168.246.0/24 -> 220.127.116.11/32
block in log all
block out log all
pass in quick log on ex0 proto tcp from any to any port = http flags S/SA keep state
pass out quick log on bge0 proto tcp from any to any port = http flags S/SA keep state
Then run ipmon, and get a client to connect through the Dell. Watch the
packets go out, and get blocked on return to the bge with bad NAT.
Swap the bge for a ex(4) 3Com 3c905C-TX. Maybe this combined with
kern/29660 might point to a fix given that these have the same chip?