>Number:         28881
>Category:       kern
>Synopsis:       tlp driver does weird things with dhcp
>Confidential:   no
>Severity:       serious
>Priority:       low
>Responsible:    kern-bug-people
>State:          open
>Class:          sw-bug
>Submitter-Id:   net
>Arrival-Date:   Thu Jan 06 03:06:00 +0000 2005
>Originator:     diro@nixsys.bz
>Release:        NetBSD 2.0_RC2
>Organization:
>Environment:
System: NetBSD lappy 2.0_RC2 NetBSD 2.0_RC2 (GENERIC_LAPTOP) #0: Wed Oct 6 04:46
:07 UTC 2004 autobuild@tgm.netbsd.org:/autobuild/netbsd-2-0/i386/OBJ/autobuild/n
etbsd-2-0/src/sys/arch/i386/compile/GENERIC_LAPTOP i386
Architecture: i386
Machine: i386
>Description:

When obtaining an IP address via DHCP (on boot, from cable modem):

tlp0: transmit process failed to idle: state RUNNING - FETCH
tlp0: receive process failed to idle: state RUNNING - FETCH
tlp0: filter setup and transmit timeout

This machine is a Compaq Armada 1700 6300/T/5000/D/M/1.

This happened with 1.6.1 to NetBSD 2.0_RC2.

[ dmesg ]

NetBSD 2.0_RC2 (GENERIC_LAPTOP) #0: Wed Oct  6 04:46:07 UTC 2004
autobuild@tgm.netbsd.org:/autobuild/netbsd-2-0/i386/OBJ/autobuild/netbsd
-2-0/src/sys/arch/i386/compile/GENERIC_LAPTOP
total memory = 65116 KB
avail memory = 57900 KB
BIOS32 rev. 0 found at 0xf0000
PCI BIOS rev. 2.1 found at 0xf046a
pcibios: config mechanism [1][x], special cycles [x][x], last bus 0
PCI IRQ Routing Table rev. 1.0 found at 0xf0990, size 80 bytes (3 entries)
pcibios_pir_init: bad IRQ table checksum
PCI IRQ Routing Table rev. 1.0 found at 0xf6fa0, size 80 bytes (3 entries)
PCI Interrupt Router at 000:07:0 (Intel 82371AB PCI-to-ISA Bridge (PIIX4) compat
ible)
PCI Exclusive IRQs: 11
------------------------------------------
device vendor product pin PIRQ IRQ stage
------------------------------------------
000:07:2 0x8086 0x7112   D  0x03  11  0    already assigned
000:17:0 0x104c 0xac17   A  0x00  11  0    already assigned
000:17:1 0x104c 0xac17   A  0x00  11  0    already assigned
------------------------------------------
PCI fixup examining 8086:7192
PCI fixup examining 8086:7110
PCI fixup examining 8086:7111
PCI fixup examining 8086:7112
PCI fixup examining 8086:7113
PCI fixup examining 102c:e5
PCI fixup examining 104c:ac17
PCI bridge 0: primary 0, secondary 1, subordinate 1
PCI fixup examining 104c:ac17
PCI bridge 1: primary 0, secondary 2, subordinate 2
PCI bus #2 is the last bus
[System BIOS Setting]-----------------------
device vendor product
register space address    size
--------------------------------------------
000:00:0 0x8086 0x7192 
10h mem  0x50000000 0x10000000
[OK]
000:07:0 0x8086 0x7110 
[OK]
000:07:1 0x8086 0x7111 
20h port 0x00001020 0x00000010
[OK]
000:07:2 0x8086 0x7112 
20h port 0x00001000 0x00000020
[OK]
000:07:3 0x8086 0x7113 
[OK]
000:08:0 0x102c 0x00e5 
10h mem  0x40000000 0x01000000
[OK]
000:17:0 0x104c 0xac17 
10h mem  0x7fffe000 0x00001000
[OK]
000:17:1 0x104c 0xac17 
10h mem  0x7ffff000 0x00001000
[OK]
--------------------------[  0 devices bogus]
Physical memory end: 0x03ff4000
PCI memory mapped I/O space start: 0x04000000
mainbus0 (root)
cpu0 at mainbus0: (uniprocessor)
cpu0: Intel Pentium II (686-class), 300.03 MHz, id 0x652
cpu0: features 183f9ff<FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,SEP,MTRR>
cpu0: features 183f9ff<PGE,MCA,CMOV,PAT,PSE36,MMX>
cpu0: features 183f9ff<FXSR>
cpu0: I-cache 16 KB 32B/line 4-way, D-cache 16 KB 32B/line 4-way
cpu0: L2 cache 512 KB 32B/line 4-way
cpu0: ITLB 32 4 KB entries 4-way, 2 4 MB entries fully associative
cpu0: DTLB 64 4 KB entries 4-way, 8 4 MB entries 4-way
cpu0: 32 page colors
pci0 at mainbus0 bus 0: configuration mode 1
pci0: i/o space, memory space enabled, rd/line, rd/mult, wr/inv ok
pchb0 at pci0 dev 0 function 0
pchb0: Intel 82443BX Host Bridge/Controller (AGP disabled) (rev. 0x02)
pchb0: fixing Idle/Pipeline DRAM Leadoff Timing
pcib0 at pci0 dev 7 function 0
pcib0: Intel 82371AB PCI-to-ISA Bridge (PIIX4) (rev. 0x02)
piixide0 at pci0 dev 7 function 1
piixide0: Intel 82371AB IDE controller (PIIX4) (rev. 0x01)
piixide0: bus-master DMA support present
piixide0: primary channel wired to compatibility mode
piixide0: primary channel interrupting at irq 14
atabus0 at piixide0 channel 0
piixide0: secondary channel wired to compatibility mode
piixide0: secondary channel ignored (disabled)
uhci0 at pci0 dev 7 function 2: Intel 82371AB USB Host Controller (PIIX4) (rev. 
0x01)
uhci0: interrupting at irq 11
usb0 at uhci0: USB revision 1.0
uhub0 at usb0
uhub0: Intel UHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub0: 2 ports with 2 removable, self powered
Intel 82371AB Power Management Controller (PIIX4) (miscellaneous bridge, revisio
n 0x02) at pci0 dev 7 function 3 not configured
vga1 at pci0 dev 8 function 0: Chips and Technologies product 0x00e5 (rev. 0xa8)
wsdisplay0 at vga1 kbdmux 1: console (80x25, vt100 emulation)
wsmux1: connecting to wsdisplay0
cbb0 at pci0 dev 17 function 0: Texas Instruments PCI1220 PCI-CardBus Bridge (re
v. 0x02)
cbb1 at pci0 dev 17 function 1: Texas Instruments PCI1220 PCI-CardBus Bridge (re
v. 0x02)
isa0 at pcib0
lpt0 at isa0 port 0x378-0x37b irq 7
com0 at isa0 port 0x3f8-0x3ff irq 4: ns16550a, working fifo
com2 at isa0 port 0x3e8-0x3ef irq 5: ns16550a, working fifo
pckbc0 at isa0 port 0x60-0x64
pckbd0 at pckbc0 (kbd slot)
pckbc0: using irq 1 for kbd slot
wskbd0 at pckbd0: console keyboard, using wsdisplay0
pms0 at pckbc0 (aux slot)
pckbc0: using irq 12 for aux slot
wsmouse0 at pms0 mux 0
sb0 at isa0 port 0x220-0x237 irq 5 drq 1: dsp v3.01
audio0 at sb0: half duplex, mmap, independent
midi0 at sb0: SB MIDI UART
opl0 at sb0: model OPL3
midi1 at opl0: SB Yamaha OPL3
pcppi0 at isa0 port 0x61
midi2 at pcppi0: PC speaker
sysbeep0 at pcppi0
isapnp0 at isa0 port 0x279: ISA Plug 'n Play device support
npx0 at isa0 port 0xf0-0xff: using exception 16
fdc0 at isa0 port 0x3f0-0x3f7 irq 6 drq 2
isapnp0: no ISA Plug 'n Play devices found
cbb0: interrupting at irq 11
cardslot0 at cbb0 slot 0 flags 0
cardbus0 at cardslot0: bus 1 device 0
pcmcia0 at cardslot0
cbb1: interrupting at irq 11
cardslot1 at cbb1 slot 1 flags 0
cardbus1 at cardslot1: bus 2 device 0
pcmcia1 at cardslot1
apm0 at mainbus0: Power Management spec V1.2
fd0 at fdc0 drive 0: 1.44MB, 80 cyl, 2 head, 18 sec
Kernelized RAIDframe activated
atapibus0 at atabus0: 2 targets
cd0 at atapibus0 drive 1: <UJDA150, , 1.02> cdrom removable
cd0: 32-bit data port
cd0: drive supports PIO mode 4, DMA mode 2
wd0 at atabus0 drive 0: <IC25N020ATCS04-0>
wd0: drive supports 16-sector PIO transfers, LBA addressing
wd0: 19077 MB, 38760 cyl, 16 head, 63 sec, 512 bytes/sect x 39070080 sectors
wd0: 32-bit data port
wd0: drive supports PIO mode 4, DMA mode 2, Ultra-DMA mode 5 (Ultra/100)
wd0(piixide0:0:0): using PIO mode 4, Ultra-DMA mode 2 (Ultra/33) (using DMA data
 transfers)
cd0(piixide0:0:1): using PIO mode 4, DMA mode 2 (using DMA data transfers)
tlp0 at cardbus0 dev 0 function 0: Xircom X3201-3 Ethernet, pass 0.3
tlp0: Ethernet address 00:10:a4:fe:1a:4f
tqphy0 at tlp0 phy 0: 78Q2120 10/100 media interface, rev. 10
tqphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
boot device: wd0
root on wd0a dumps on wd0b
root file system type: ffs
tlp0: interrupting at 11
tlp0: transmit process failed to idle: state RUNNING - FETCH
tlp0: receive process failed to idle: state RUNNING - FETCH
tlp0: transmit process failed to idle: state RUNNING - FETCH
tlp0: receive process failed to idle: state RUNNING - FETCH
tqphy0 detached
tlp0 detached
tlp0 at cardbus0 dev 0 function 0: Xircom X3201-3 Ethernet, pass 0.3
tlp0: Ethernet address 00:10:a4:fe:1a:4f
tqphy0 at tlp0 phy 0: 78Q2120 10/100 media interface, rev. 10
tqphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
wsdisplay0: screen 1 added (80x25, vt100 emulation)
wsdisplay0: screen 2 added (80x25, vt100 emulation)
wsdisplay0: screen 3 added (80x25, vt100 emulation)
wsdisplay0: screen 4 added (80x25, vt100 emulation)

>How-To-Repeat:

Set up dhclient to run on boot. Or lose the carrier, reconnect, and attempt to use dhclient without first removing the device and killing dhclient.

>Fix:

Remove device. Kill dhclient. Restart cable modem. Reattach device. Start dhclient.