Subject: Re: progress bar problem while reconstructing RAIDframe disk
To: None <email@example.com>
From: Jukka Salmi <firstname.lastname@example.org>
Date: 05/13/2005 15:12:33
Alistair Crooks --> current-users (2005-05-13 13:49:19 +0100):
> On Fri, May 13, 2005 at 01:15:16PM +0200, Jukka Salmi wrote:
> > Hi,
> > I'm using RAIDframe (level 1) on a 3.99.3 i386 system with two IDE disks.
> > Becuase of a problem I was having with one of the drives, and decided to
> > switch the drives. Luckily I had a spare, so I could do this by
> > - replacing drive A (original wd0) with the spare
> > - reconstructing onto the spare
> > - replacing drive B (original wd1) with drive A
> > - reconstructin onto drive A
> > - replacing the spare with drive B
> > - reconstructing onto drive B
> > The toughest part of this process was to not mix the drives while switching
> > them around...
> > Eventually everything went fine; however, while reconstructing the disks
> > I noticed a problem: the first time I reconstructed, the progress bar
> > stalled at 29% and ETA constantly increased until reconstruction eventually
> > succeeded. During the other two reconstructions, the progress bar always
> > printed 0% and ETA 0:00 until it completed. However, reconstruction was
> > always successful (AFAICT), and never took longer than expected.
> > What could be the source if this problem?
> There were some 32-bit overflow problems with raidctl which Greg fixed
> recently - I saw some 64 bit values were being returned properly, but
> were being stored in 32 bit values.
I used an up-to-date raidctl:
$ ident /sbin/raidctl
$NetBSD: crt0.c,v 1.13 2003/07/26 19:24:27 salo Exp $
$NetBSD: rf_configure.c,v 1.22 2005/02/09 14:21:37 xtraeme Exp $
$NetBSD: raidctl.c,v 1.37 2005/05/01 22:37:34 oster Exp $
$ ((RANDOM%6)) || rm -rf ~