Subject: Re: PERC4/SC RAID compatibility
To: Martti Kuparinen <martti.kuparinen@iki.fi>
From: Cameron Brown <cameron@amitconsulting.info>
List: current-users
Date: 10/22/2004 14:12:42
Martti:

It does seem to me that everything is properly selected for RAID, Mass =
Storage, et al.  Whatever the case, I have played with the configuration =
in several ways, and each time I get the same output you specify below.  =
Also, as I said, I am using NetBSD BIOS 2.11 NOT 2.99.10


    In the System BIOS Setup
         - Integrated Drive Controller is set to AUTO (versus OFF).
         - I have flipped the Hard Drive Boot order back and forth, with =
the same output, no change.

    In the RAID Configuration Setup
         - BIOS Enabled
         - Emulation Mass Storage

When I first boot I see a message seeming to recognize the logical drive =
saying:

1 Logical Drive found on host adapter
1 Logical drive(s) handled by BIOS

Blah blah blah... I can do some more research on my end.  Let me know =
what you need from me.  I am not a BIOS nor kernal guru and I don't =
pretend to be.

Thanks,
Cameron





----- Original Message -----=20
From: "Martti Kuparinen" <martti.kuparinen@iki.fi>
To: "Cameron Brown" <cameron@amitconsulting.info>
Cc: <current-users@NetBSD.org>; <port-i386@NetBSD.org>
Sent: Friday, October 22, 2004 1:16 AM
Subject: Re: PERC4/SC RAID compatibility


> Cameron Brown wrote:
>=20
>> vendor 0x1000 product 0x1960 (RAID mass storage, revision 0x01) at =
pci2 dev 1 function 0 not configured
>=20
> Are you sure you have selected RAID instead of SCSI in your BIOS
> for the integrated controller? Also make sure you have "mass storage"
> instead of "I20" as the RAID mode.
>=20
> The reason I'm asking is that vendor 0x1000 is Symbios and that's
> the same controller I'm getting on PowerEdge 1850 if I select SCSI
> instead of RAID. When RAID is selected the vendor is 0x1028.
>=20
> So please verify the settings and send a new dmesg output if you
> changed anything. Let me also know if these were in fact correct
> values and you didn't change anything in the BIOS
>=20
> Martti
>