On Thursday 29 July 2004 13:09, Barry Bouwsma wrote:
> Finally I installed NetBSD-current, and booted from the USB2
> drive as my OS disk.  I get the following at boot, but I've
> had no problems in minor attempts to pound the disk so far.
>
> umass0 at uhub2 port 1 configuration 1 interface 0
> umass0: Maxtor 5000XT v01.00.00, rev 2.00/1.00, addr 2
> umass0: using SCSI over Bulk-Only
> ehci_idone: need toggle update status=80018d40 nstatus=80008c80
> ehci_idone: need toggle update status=80028d40 nstatus=80008c80
> scsibus0 at umass0: 2 targets, 1 lun per target
> sd0 at scsibus0 target 0 lun 0: <Maxtor, 5000XT v01.00.00, 0100> disk fixed
> sd0: 233 GB, 16383 cyl, 16 head, 63 sec, 512 bytes/sect x 490232832 sectors

The "need toggle update" message is actually just informational in NetBSD at 
this point.  I left it in so that I would know the code is getting used and 
working.  (There are still some lurking gremlins related to short packets, 
but I've been hesitant to work on that without a device -- primarily tape 
drives -- that I can adequately test it with.)