On Wed, Sep 18, 2002 at 01:05:25AM -0400, Russell Neches wrote:
> 
> Hey there --
> 
> I'm attempting to configure an Adaptec 4 port NIC (the 6915 card), and
> I seem to have been able to build a kernel that will use it. However,
> the machine hangs when configuring the last interface:
> 
> sf0 at pci3 dev 4 function 0: ANA-62011 (rev 0) 10/100 Ethernet, rev 3
> sf0: interrupting at ivec 10
> sf0: Ethernet address 00:00:d1:ec:f5:59
> sf0: 64-bit PCI slot detected
> sqphy0 at sf0 phy 1: Seeq 80220 10/100 media interface, rev. 1
> sqphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
> 
> sf1 starts up....
> sf2 starts up....
> 
> sf0 at pci3 dev 7 function 0: ANA-62011 (rev 0) 10/100 Ethernet, rev 3
> [ hang ]
> 
> I'm running NetBSD 1.6. I seem to recall reading about a problem
> similar to this while I was researching this card, but I can't find
> the reference again. Any suggestions?

This was with a Sun 4-port HME adapter I think, and it was on sbus.
Check the sparc or sparc64 archives.

-- 
Manuel Bouyer <bouyer@antioche.eu.org>
--