At 09:52 AM 5/14/2002, Manuel Bouyer wrote:
>Interesting. I have a SCSI2 and a SCSI3 device connected to a 1010 (bus in
>SE mode, though) and some SCSI3 connected to a 895 and I don't have this
>problem.
>Maybe your drive has a bug, and claim to only support DT clocking when
>it's not true ? The attached patch should confirm this.

That "fixed" the problem but looking throught the scsipi code, I don't
think DT is handled properly.  DT implys WIDE16/SYNC which the code clears.
That seems wrong.  Also the periph_cap code doesn't about DT and so doesn't
print correct drive information.  Also, I don't any negotiation is done for
DT and that's wrong as well.

-- 
Matt Thomas               Internet:   matt@3am-software.com
3am Software Foundry      WWW URL:    http://www.3am-software.com/bio/matt/
Cupertino, CA             Disclaimer: I avow all knowledge of this message