Hello,

I just put a Netgear GA620 card in a i386 box, 32 bit slot.
With NetBSD1.5_BETA the card recognised correctly:

ti0 at pci0 dev 9 function 0: Netgear GA620 Gigabit Ethernet (rev. 0x01)
ti0: interrupting at irq 9
ti0: Ethernet address: 00:02:e3:00:04:ff

But I can't activate the card as the ifconfig output shows:

ti0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> mtu 1500
        address: 00:02:e3:00:04:ff
        media: Ethernet 1000baseSX (autoselect)
        status: no carrier
        inet 194.94.211.221 netmask 0xffffff00 broadcast 194.94.211.255

The link LED on the switch is on, but on the GA620 off.

Any suggestions ?

Best regards
Uwe