My command line was as follows (just for a simple copy operation):

cdrdao copy --source-device 1,3,0 --device 1,2,0

Thanks,
Edwin

-----Original Message-----
From: Wolfgang Rupprecht [mailto:wolfgang@wsrcc.com]
Sent: Tuesday, February 08, 2000 11:31 AM
To: Edwin Foo
Cc: Pallen; current-users@netbsd.org
Subject: RE: CD-TEXT under NetBSD?



Edwin Foo writes:
> cd1 at scsibus1 targ 3 lun 0: <PLEXTOR, CD-ROM PX-40TS, 1.10> SCSI2
5/cdrom
> ERROR: Cannot open SCSI device '1,2,0':
> ERROR: Cannot open SCSI device '1,3,0':

Unfortunately my plextor is on an atapi/ide bus and runs the scsi
command set over atapi.  I'm not 100% sure what the scsibus/targ/lun
should look like after all the remapping magic.

You didn't say exactly what you specified as the device.  Was it 
"--device /dev/cd1" or "--device 1,3,0"?  Did you try "--device /dev/cd1d"?

-wolfgang
-- 
Wolfgang Rupprecht    <wolfgang@wsrcc.com>
http://www.wsrcc.com/wolfgang/
DGPS signals via the Internet
http://www.wsrcc.com/wolfgang/gps/dgps-ip.html