Hi folks...

I've gotten the 21142/21143 working, at least minimally, in my `tlp' driver.
Performance is pretty good, using SIA and SYM media.  I'll do MII media
soon, but it's going to require another round of the rototiller to get
it right (sigh, chip ... too ... flexible :-).

I seem to have broken Macronix support in the process, however, so I'm not
going to commit it until I get that worked out.  Appended below is some
dmesg output for your enjoyment.

Have a nice Halloween, folks... bob for apples, and all that.

        -- Jason R. Thorpe <thorpej@nas.nasa.gov>
Loading netbsd...
3007560+375824 [85+175824+96924]

Entering netbsd at 0xfffffc0000301170...
[ preserving 273736 bytes of netbsd ELF symbol table ]
Copyright (c) 1996, 1997, 1998, 1999
    The NetBSD Foundation, Inc.  All rights reserved.
Copyright (c) 1982, 1986, 1989, 1991, 1993
    The Regents of the University of California.  All rights reserved.

NetBSD 1.4M (BISHOP) #918: Fri Oct 29 17:03:04 PDT 1999
    thorpej@bishop:/amd/dracul/u2/netbsd/src/sys/arch/alpha/compile/BISHOP
Digital AlphaStation 500/500, 500MHz
8192 byte page size, 1 processor.
total memory = 256 MB
(2200 KB reserved for PROM, 253 MB used by NetBSD)
avail memory = 232 MB
using 1637 buffers containing 13096 KB of memory
mainbus0 (root)
cpu0 at mainbus0: ID 0 (primary), 21164A-0 (unknown minor type 0)
cia0 at mainbus0: DECchip 2117x Core Logic Chipset (ALCOR/ALCOR2), pass 3
cia0: extended capabilities: 21<DWEN,BWEN>
cia0: using BWX for PCI config access
pci0 at cia0 bus 0
pci0: i/o enabled, memory enabled
tlp0 at pci0 dev 6 function 0: DECchip 21040 Ethernet, pass 2.6
tlp0: interrupting at kn20aa irq 13
tlp0: Ethernet address 00:00:f8:25:56:c5
tlp0: manual, 10base5, 10baseT-FDX, 10baseT
tlp0: supplying EUI64: 00:00:f8:ff:fe:25:56:c5
sf0 at pci0 dev 7 function 0: Adaptec AIC-6915 Ethernet, rev. 3
sf0: ANA-62011 Single64 Rev. 1, 64-bit bus connection
sf0: interrupting at kn20aa irq 8
sf0: Ethernet address 00:00:d1:a8:16:08
sqphy0 at sf0 phy 1: Seeq 80220 10/100 media interface, rev. 1
sqphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
tlp1 at pci0 dev 8 function 0: DECchip 21140A Ethernet, pass 2.0
tlp1: interrupting at kn20aa irq 16
tlp1: DEC DE500-AA, Ethernet address 00:00:f8:05:c1:cc
nsphy0 at tlp1 phy 5: DP83840 10/100 media interface, rev. 0
nsphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
isp0 at pci0 dev 9 function 0
isp0: interrupting at kn20aa irq 12
isp0: Board Revision 1020A, loaded F/W Revision 40.0.0
isp0: Last F/W revision was 5.1.1
isp0: 124 max I/O commands supported
isp0: driver initiated bus reset of bus 0
scsibus0 at isp0: 16 targets, 8 luns per target
pceb0 at pci0 dev 10 function 0: Intel 82375EB/SB PCI-EISA Bridge (PCEB) (rev. 0x15)
tlp2 at pci0 dev 11 function 0: Macronix MX98715A Ethernet, pass 2.0
tlp2: interrupting at kn20aa irq 0
tlp2: Ethernet address 00:80:c6:f7:9d:06
tlp2: 100baseTX-FDX, 100baseTX, 10baseT-FDX, 10baseT
ppb0 at pci0 dev 12 function 0: Digital Equipment DECchip 21052 PCI-PCI Bridge (rev. 0x00)
pci1 at ppb0 bus 1
pci1: memory enabled
tlp4 at pci1 dev 5 function 0: DECchip 21143 Ethernet, pass 3.0
tlp4: interrupting at kn20aa irq 5
tlp4: DEC DE500-BA, Ethernet address 00:00:f8:03:cf:87
tlp4: 100baseTX-FDX, 100baseTX, 10baseT-FDX, 10baseT
tlp5 at pci1 dev 6 function 0: Lite-On 82C115 Ethernet, pass 2.5
tlp5: interrupting at kn20aa irq 6
tlp5: Ethernet address 00:a0:cc:35:68:66
tlp5: 100baseTX-FDX, 100baseTX, 10baseT-FDX, 10baseT
eisa0 at pceb0
isa0 at pceb0
com0 at isa0 port 0x3f8-0x3ff irq 4: ns16550a, working fifo
com0: console
com1 at isa0 port 0x2f8-0x2ff irq 3: ns16550a, working fifo
lpt0 at isa0 port 0x3bc-0x3bf irq 7
pckbc0 at isa0 port 0x60-0x64
pcppi0 at isa0 port 0x61
spkr0 at pcppi0
isapnp0 at isa0 port 0x279: ISA Plug 'n Play device support
fdc0 at isa0 port 0x3f0-0x3f7 irq 6 drq 2
fd0 at fdc0 drive 0: 1.44MB, 80 cyl, 2 head, 18 sec
mcclock0 at isa0 port 0x70-0x71: mc146818 or compatible
isapnp0: no ISA Plug 'n Play devices found
scsibus0: waiting 2 seconds for devices to settle...
isp0: Bus 0 Target 0 Async Mode
sd0 at scsibus0 targ 0 lun 0: <DEC, RZ1CB-BS (C) DEC, 0658> SCSI2 0/direct fixed
sd0: 4091 MB, 3708 cyl, 20 head, 113 sec, 512 bytes/sect x 8380080 sectors
isp0: Bus 0 Target 4 Async Mode
cd0 at scsibus0 targ 4 lun 0: <DEC, RRD46   (C) DEC, 0557> SCSI2 5/cdrom removable
IPsec: Initialized Security Association Processing.
root on sd0a dumps on sd0b
isp0: Bus 0 Target 0 at 10MHz Max Offset 12, 16 bit wide, Tagged Queueing Enabled
isp0: Bus 0 Target 0 at 10MHz Max Offset 12, 16 bit wide, Tagged Queueing Enabled
isp0: Bus 0 Target 0 at 10MHz Max Offset 12, 16 bit wide, Tagged Queueing Enabled
isp0: Bus 0 Target 0 at 10MHz Max Offset 12, 16 bit wide, Tagged Queueing Enabled
isp0: Bus 0 Target 0 at 10MHz Max Offset 12, 16 bit wide, Tagged Queueing Enabled
isp0: Bus 0 Target 0 at 10MHz Max Offset 12, 16 bit wide, Tagged Queueing Enabled
isp0: Bus 0 Target 0 at 10MHz Max Offset 12, 16 bit wide, Tagged Queueing Enabled
root file system type: ffs