Subject: Re: i386: ethernet problems with 1.3_ALPHA boot image?
To: Eric S. Hvozda <firstname.lastname@example.org>
From: Curt Sampson <email@example.com>
Date: 11/05/1997 22:03:05
> I see the i386 1.3A snapshot is out there so I thought I'd give it a
> spin. However, I seem to have quite the odd behavior WRT to my
> ethernet card. It autoconfs fine, however when I try to use it, I
> always get "ed2: device timeout".
Uh, where on earth is the ed2 driver in that 1.2.1 boot message
This message is often due to an interrupt being set wrong. Are you
absolutely positive your card is at IRQ 10?
If it is, is it an SMC card? I would hope that that problem hasn't
come back to haunt us again....
Curt Sampson firstname.lastname@example.org Info at http://www.portal.ca/
Internet Portal Services, Inc. Through infinite myst, software reverberates
Vancouver, BC (604) 257-9400 In code possess'd of invisible folly.