I'm having a small bit of trouble getting the initial partitioning done 
on my disk...i recieve the following error when trying to write the 
information I have entered... 
 
si0: can not transfer more data 
si0: aborting, but phase=DATA_OUT (reset) 
si0: reset SCSI bus for TID=0 LUN=0 
panic: ncr5380_scsi_cmd: polled request, abort failed 
 
Kernel the reboots afterward...I get this when using _both_ disklabel and 
edlabel... is this a problem with the drive or the controller?? 
 
 
Any help would be greatly appreciated 


 
--Dave 
--v^v--v^v--v^v-------------------------------------------------Phlatline 
Out the interface, through the subnet, over the router, through the other  
subnet, out the Gateway...Nothing but 'Net.