Subject: Cirrus console
To: NetBSD Amiga <amiga@NetBSD.ORG>
From: Matthias Scheler <email@example.com>
Date: 04/28/1995 22:52:13
I just compile my first kernel with cirrus console, but I have two problems
1.) My monitor is not able to center the display properly. I can't move
the screen to the right. If I reduce the width to the minimum I'm able
to read everything except the first column.
I doubt that it is the monitor's fault. It is an Eizo F555i-M which was
able to display all modes by VillageTronic's software and CyBERgraphics.
Even a SPARCStation II worked without any problems.
Maybe a console mode definition with a standard VGA mode would help.
Could anyone supply me something like this?
2.) If I boot into single used mode the Cirrus console displays all the
output but doesn't accept any input. Yes, I created "grf3" and "ttye3"
and added "ttye3" to "/etc/ttys".