Re: Radeondrm w/RV370 / X300 SE on 7.0_BETA -- working?

[Havard Eidnes <he%NetBSD.org@localhost>]

>    (I will have a serial console on this host in a while, I'm
>    currently missing a cable + back-plane connector for the on-board
>    serial header.)
>
>    However, I'd like to ask if this combination is "supposed" to
>    work, in other words if this is a new and unknown problem.
>
> New and unknown problem.  Serial console may help.  Can you also show
> any radeon messages near the end of the dmesg?  Most of radeon
> attachment happens late so it can load firmware from the file system.

Hm, not much to see there:

atapibus0 at atabus27: 2 targets
cd0 at atapibus0 drive 0: <ATAPI   iHAS324   E, 3524679 27841650145, 4L16> 
cdrom removable
cd0: 32-bit data port
cd0: drive supports PIO mode 4, DMA mode 2, Ultra-DMA mode 5 (Ultra/100)
cd0(piixide1:0:0): using PIO mode 4, Ultra-DMA mode 5 (Ultra/100) (using DMA)
wd0 at atabus28 drive 0
wd0: <WDC WD1200JS-00NCB1>
wd0: drive supports 16-sector PIO transfers, LBA48 addressing
wd0: 111 GB, 232581 cyl, 16 head, 63 sec, 512 bytes/sect x 234441648 sectors
wd0: 32-bit data port
wd0: drive supports PIO mode 4, DMA mode 2, Ultra-DMA mode 6 (Ultra/133)
wd0(piixide1:1:0): using PIO mode 4, Ultra-DMA mode 6 (Ultra/133) (using DMA)
Kernelized RAIDframe activated
pad0: outputs: 44100Hz, 16-bit, stereo
audio1 at pad0: half duplex, playback, capture
boot device: wd0
root on wd0a dumps on wd0b
/: replaying log to memory
root file system type: ffs
/: replaying log to disk
/var: replaying log to disk
/usr: replaying log to disk
wsdisplay0: screen 1 added (80x25, vt100 emulation)
wsdisplay0: screen 2 added (80x25, vt100 emulation)
wsdisplay0: screen 3 added (80x25, vt100 emulation)
aibs0: warning under limit on 'POWER FAN Speed'
wsdisplay0: screen 4 added (80x25, vt100 emulation)

is the end of the dmesg output.  Where's the firmware to be
loaded from?  Does that happen only when X11 is started, or
should it happen before wsdisplay0 is configured?

> Also: file a PR and assign it to me?

OK, will do.

Regards,

- Håvard