Dear Herb,
   Over Thanksgiving break I was able to check to see if the driver
for 25MHz Efficent which I wrote worked on was operational on various
versions.  I was able to get 1.3.3 to talk to 1.4 and 1.4.1 to talk to
1.4.  Those were the only configurations I tried.  So as far as I know
the problem is not in the ATM layer.
   I configured the interfaces and set up routing via ifconfig and route.
johnh...
On Thu, 28 Oct 1999, John C. Hayward wrote:

> On Thu, 28 Oct 1999, Herb Peyerl wrote:
> 
> > "John C. Hayward" <John.C.Hayward@wheaton.edu>  wrote:
> >  > You might find the paper which Chuck Cranor did at:
> >  > http://www.ccrc.wustl.edu/pub/chuck/psgz/bsdatm.ps.gz
> >  > which describes how to configure PVC using his mods.
> >  > I wrote a driver for Efficient 25MHz card with the lanai chip set and
> >  > was able to configure the routing as described in the previous URL.
> >  > This was on a 1.3.3 and 1.4 system.
> >  > This does not use pvcsif to my knowlege.
> > 
> > As stated earlier, I have it working fine on 1.3B. Going to 1.4 or 
> > later has it not working.
> > 
> > So you're saying you have it working on the 1.4 release?
> I thought I was stating that I had my driver working using the route stuf
> to configure the PVC on a 1.4 system.  Now I am not 100% sure - I know I
> had been able to get activity with a 1.3.3 system and about that time I 
> migrated my driver to 1.4 but at about that time our ISP turned off CLIP
> so I'm not 100% sure that everything is working in 1.4.
> 
> Sorry I cannot be more helpful.
> 
> johnh...
> 
>